Nu introducerar vi GP2!
High End preamp och Connectall box.


GP2 Pre-amp is designed with the knowledgeable user in mind. It picks up where the standard preamp leaves off. Basically, hiss free and harmonic distortion almost too low to measure. The sound is very robust and holds up under wild equalization. No mid-range fog or harshness, as with other pre-amps. The entire mid-range is well defined and allows for a whole new experience in the studio. The top end is smooth with ‘air’ but no roughness. Extends easily beyond hearing range. ( No bumping at around 8k or lack of air) Headroom is exceptional Almost impossible to get distortion

For the user who doesn’t want the classic English ‘processed’ sound or the American ‘harshness’ This is obviously the best pre-amp on the market.


On his most recent recordings with the “Kaiser Orchestra” in Berlin Germany Mark tested the new GP2 cables and prototype of the Pre-amp currently being developed.


Daniel Lanois
Producer/Singer Songwriter

GP2 will manuacture a pre-amp that Dan has been using for 20 years. With a focus on premium components, and high quality workmanship. Dan is excited to retire his prototype pre-amp in exchange for GP2's new and improved equipment.

"Finally my favourite pre-amp is on the market"
Daniel Lanois

Connectall Box


Audio Adapter:
separates stereo signal to 2 channel
provides attentuated 1 and 2 channel
combines attenuated 1 & 2 channel into Stereo Output
Also used to adapt connector types ie. xlr to 1.4 inch
"Musicians duct tape"
1001 uses when configuring your setup


GP2 Specifications
990C Sepcifications (0dBu = 0.775V) :

Measurement Spec. Units
Open-loop gain, DC to 30Hz 125 dB
Gain error at 100dB gain 0.4 dB
Noise-voltage spectral density,
each transistor 0.8 nV/vHz
differential pair 1.13 nV/vHz
Noise current spectral density 1 pA/vHz
Noise index,
1kO source resistance 0.6 dB
Equivalent input noise voltage,
20kHz bandwidth, shorted input 160 nV
Corresponding voltage level -133.7 dBu
Maximum input voltage at unity gain 13.8 V
Corresponding voltage level +25 dBu
Input impedance, non-inverting output >10 MO
Input bias current +2.2 µA
Maximum output voltage,
RL = 75O 13.8 V
Corresponding voltage level +25 dBu
Maximum peak output current 260 mA
Total harmonic distortion at 20kHz,
VOUT = +24 dBu
RL = 75O, gain = 40dB 0.06 %
RL = 75O, gain = 20dB 0.005 %
RL = 600O, gain = 40dB 0.015 %
Slew rate, RL = 150O 18 V/µS
Slew rate, RL = 75O 16 V/µS
Large-signal bandwidth,
at unity gain (ft) 10 MHz
Gain-bandwidth product,
10kHz to 100kHz >50 MHz
Phase margin at 10MHz >38 deg
Phase margin at <2MHz >60 deg
Response time at unity gain <20 nS
Supply current with no load 25 mA

 

Kontakta oss för alla detaljer och mer info. Vi har GP2 hemma för test.
Besök även Gp2´s hemsida på: www.gp2inc.com